LED rope light led tape enclosed LED power supply junction box 12v 150w 12a
SMT-012-150VWJ is used in 110vac , 220vac, 277vac input voltage, 12vdc output voltage , 150w wattage LED applications. enclosed junction box and led driver 2 in one version, It is easier to install than meanwell's 150W power supply, and the wiring is simpler.this is also a UL cUL listed non dimmable led driver with single output.
Specifications
Model
SMT-012-150VWJ
SMT-024-150VWJ
Output
DC Voltage
12V
24V
Voltage Tolerance
±0.5V
Voltage Tolerance
±0.5V
Voltage Regulation
±0.5%
Rated current
12.5A
6.25A
Rated power
150W
Input
Voltage Range
100-277VAC
Frequency Range
47～63HZ
Power Factor ( Typ.）
0.99@120V ;0.97@230V ;0.95@277V
0.99@120V ; 0.97@230V ;0.95@277V
Full Load
Efficiency（Typ.）
>88%
>88%
AC Current（Typ.）
1.82A@110VAC 1.32A
Inrush Current （Typ.）
15A,50% ,1.4ms@120V;55A,50% 220us@230V;30A,50% 1.4ms@277V
Leakage current
<0.50mA
Protection
Short Circuit
shut down o/p voltage, re-power on to recover after fault condition is removed
Over load
≤120% constant current limiting, auto-recovery
TEMP .coefficient
±0.03%/℃（0～50℃）
Vibration
10～500Hz, 5G 10min./1 cycle,period for 60min. each along X,Y,Z axes
Over Current
≤1.4*I out
Environment
Working TEMP.
-40～+60℃
Working Humidity
20～90%RH,non-condensing
Storage TEM.,Humidity
-40～+80℃，10～95%RH
TEMP.coefficient
±0.03%/℃（0～50℃）
Vibration
10～500Hz 2G 10min./1 cycle，period for 60min.each along X,Y,Z axes
Safety&EMC
Safety standards
UL8750
Withstand voltage
I/P-O/P:2.5KVAC
Isolation resistance
I/P-O/P：100MΩ/500VDC/25℃/70%RH
EMC EMISSION
FCC Part 15 B
EMC IMMUNITY
EN61000-4-2,3,4,5,6,11（Surge about 4KV）
Others
N.W.
1.8Kg/pcs
Size
260*103*46mm (L*W*H)
packaging
440*295*145mm ,10PCS/CTN
Notes
1. All parameters NOT specially mentioned are measured at 110VAC, 277VAC input , rated
load and 25℃of ambient temperature.
2..Tolerance:includes set us tolerance,line regulation and load regulation .
Label
 |
 |
 |
 |
Answer: A common question that customers ask is: “Can I use an LED lights that has a higher wattage equivalent than the LED drivers?” The answer is NO. in the applications, its normal to give around 90-100% load to led driver. but won't suggest to give overload. that's say, if its a 12v 150w LED driver for LED light, max.140w load is optimal. it is referring the dangers of high heat output associated with LEDs and LED drivers.
All drivers from SMARTS has protection of overload, if it comes the highest point, drivers will have overload protection automatic, and resume work as soon as the fault release.
Drawing
Connecting diagram
